Hama EWS Intro Bedienungsanleitung Seite 7

Note – Snooze function
• While the alarm is sounding, press the Z/Register
button (23) to activate the snooze function. The snooze
z
Z
symbol and alarm symbol
the display. The alarm signal will stop for approximately
5 minutes, after which it will sound again.
• Press the SELECT button (24) to stop the snooze
function and the alarm.
Temperature (Celsius/Fahrenheit)
• Press and hold the SELECT button (24).
• Press the SET/RESET button (25) to choose between °C and
°F for the temperature display.
• Confirm your selection by pressing the SELECT button (24).
• The weather station indicates a trend as to how the values
for the outdoor temperature and room temperature are likely
to develop over the next few hours.
Display
6.3 Maximum and minimum temperature values
• The base station automatically stores the maximum and
minimum outdoor/indoor temperature values.
• Press the SELECT button (24) to display the maximum
values. Press the SELECT button (24) again to display the
minimum values.
• Press the button a third time to go to the standard view.
6
begin to flash on
/
1 2
Trend
Increasing
Constant
Decreasing
7. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth and
do not use aggressive cleaning agents. Make sure that water
does not get into the product.
8. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no
warranty for damage resulting from improper installation/
mounting, improper use of the product or from failure to
observe the operating instructions and/or safety notes.
9. Service and Support
Please contact Hama Product Consulting if you have any
questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com