Operation - Hama EWS Intro Bedienungsanleitung

Note
• The wireless transmission range between the measuring
station and base station is up to 30 m in open spaces.
• Before installation, ensure that wireless transmission
will not be disrupted by interference or obstacles like
buildings, trees, vehicles, high-voltage lines, etc.
• To avoid transmission interference, do not operate
adjacent wireless devices on the same frequency
(433 MHz).
• Before the final installation, ensure that there is sufficient
reception between the intended installation locations.
• When installing the measuring station, ensure that it is
protected from direct sunlight and rain.
• The international standard height for measuring air
temperature is 1.25 m (4 ft) above ground.
Warning
• Buy special or suitable installation material from a
specialised dealer for wall-mounting.
• Ensure that no faulty or damaged parts are installed.
• Never apply force during installation. This could damage
the product.
• Before installation, ensure that the chosen wall is
suitable for the weight to be mounted, and make sure
that there are no electrical wires, water, gas or other
lines at the installation site on the wall.
5.1 Base station
• Use the base (27) to position the base station on a level
surface.
• Alternatively, you can install the base station on a wall using
the opening (20) on the back.
5.2 Measuring station
• You can also position the measuring station on a level
outdoor surface.
• We recommend installing the measuring station securely on
an outdoor wall using the recess (29).
• Install an anchor, screw, nail, etc. in the wall of your choice.
• Hang up the base/measuring station using the opening (29)
intended for this purpose.
4

6. Operation

6.1 Connection to the measuring station
• When the batteries have been inserted, the base station
automatically searches for a connection to the measuring
station and to the radio signal.
Note
• The first search for the measuring station can take up
to 3 minutes; the search for the radio signal can take
up to 7 minutes.
• If the base station receives no signal from the measuring
station, it automatically begins to search for the radio
signal after 3 minutes.
• The respective symbols will flash during the connection
attempts: connection to the measuring station,
connection to the DCF signal
• Do not press any buttons during setup. Otherwise, values
may not be transmitted correctly and there is a risk of
value errors and inaccuracies.
• Do not change the location of the base station during
the search processes.
• The process is completed when the indoor (17) and
outdoor (13) measurement data is displayed.
6.2 Basic and manual settings
Automatic setting using the DCF signal
When the base station has been switched on for the first time
and successful transmission has been established between
the base station and the measuring station, the clock will
automatically search for the DCF signal. During the search, the
radio symbol flashes.
Display
Flashing display
Constant display
No display
Search for the DCF signal
Active
Successful –
signal is being received
Inactive