System Settings; Calling The System Settings; Delete All Dmx Assignments [Delete All Fixture Patch]; Reset To Factory Settings [Reset Factory] - EuroLite Color Chief 700064575 Bedienungsanleitung

Calling the system settings

1 Keep the button MENU/ESC for 3 seconds to call the system settings.
The upper display indicates the first menu item "01. Patch fixture".
2 Use the encoder wheel to browse the menu items.
3 Press the ENTER button to select the desired menu item.
4 Use the encoder wheel to change a setting and confirm with ENTER.
5 Shortly press the MENU/ESC button to abort the setting procedure and return to the main menu level.
6 To save your settings and exit the system settings, keep the MENU/ESC button pressed for 3 seconds.
The following adjustments are possible:
Display
01. Patch fixture
02. Delete all fixture patch
03. Reset factory
04. USB Data backup
#1
This menu item is covered in chapter Patching and managing devices.
#2
This function is not available.

Delete all DMX assignments [Delete all fixture patch]

All address assignments and control channel options made can be deleted and reset to the presettings.
1 Call the menu item [Delete all Fixture patch].
2 Select the setting [YES] with the encoder wheel if a reset is to be made. Confirm with ENTER.
The display shortly indicates "Delete all patch ok" and returns to the main menu level.

Reset to factory settings [Reset factory]

It is possible to reset the controller to factory setting. All programs and fixture patches will be deleted.
Call the menu item [Reset factory].
1
2 Select the setting [YES] with the encoder wheel and confirm with ENTER.
The display shortly indicates "Please wait ...." and then "Reset setup ok" as soon as the factory settings are
loaded.

Data backup [USB Data backup]

All settings of a light show, i.e. DMX settings and programs can be stored on a USB memory device. 24 memory
banks are available.
1 Connect a USB memory device to the controller's USB port.
2 Call the menu item [USB Data backup].
3 Select the setting [YES] with the encoder wheel and confirm with ENTER. The display indicates "Press chase
select file" (select memory bank with number button).
4 Select a memory bank with one of the number buttons 1-24. The display shortly indicates e.g. "FILE: 1..."
and then "File save ok".
● Each memory bank must be stored separately. If the LED of a number button lights, this memory bank has
been stored on the USB memory device before (rewriting is possible).
● The data will be stored in the folder "COLORCHIEF" located on the root directory of the USB memory device.
A file with the extension "PRO" will be created for each memory bank. You should not make any changes to
the default folder. Otherwise the controller cannot the reload the data later.
5 After completing the data backup, the device returns to the main menu level.
REGARDING USB MEMORY DEVICES
● This unit supports data carriers with the file system FAT32 and with a capacity up to 32 GB.
● Prior to connecting a USB memory device, call the system settings.
● If a data carrier is not recognized at the first try, turn the controller off and on again

SYSTEM SETTINGS

Function
#1
DMX configuration
Delete all fixture assignments
Reset to factory settings
Data backup
.
Display
05. USB Data load
06. Send Update file
07. Fixture LIB Manage
31 • EN
Function
Data import
#2
Firmware update
Fixture library