Settings - EuroLite Stage Control 136 Bedienungsanleitung

Settings

Enter the setting mode
Press the SETUP button (11) for 5 seconds while no program running, relevant LED will light up.
LCD will show you:
(3.P/T FADE ONLY 4.DISPLAY MODE 5.MIDI CH. )
Use the UP/DOWN buttons (17 & 18) to scroll, RECORD (15) to enter, and ESC (16) to exit.
Save data to the CF card
Enter the setting mode, then choose "1. CF-CARD" and press RECORD button (15), the LCD will show:
Then please press UP/DOWN (17 & 18) to choose "2. STORE TO CF", press RECORD (15) again for further
operation.
Select relevant location (1-99) by UP/DOWN buttons to save the data, and then press the RECORD button
(15) for recording, press the ESC button (16) to exit.
Read from the CF card
Enter the setting mode, then choose "1. CF-CARD" and press RECORD, the LCD will show you:
Use UP/DOWN buttons to choose "1. READ FROM CF", and press the RECORD button (15) to enter.
Select relevant location (1-99) by UP/DOWN buttons (17 & 18), and press the RECORD button (15) for data
reading, use ESC (16) to cancel or exit.
Patch channel (assign)
Enter the setting mode to choose "2. ASSIGN CH." and press RECORD (15) to enter channel distributing
mode. LCD shows:
Select the fixtures to be distributed.
Use UP button to select relevant channel number, and press DOWN to select the channel number to be
distributed.
Press RECORD button (15) to confirm, and press ESC button (16) to cancel or exit.
PAN / TILT FADE ONLY
Enter the setting mode to choose item "3. P/T FADE ONLY", and press the RECORD button (15) to enter
"PAN/TILT FADE ONLY" mode.
Further information will be shown on the LCD:
Select fixtures by the UP button, and press the DOWN button to select "FADE ONLY" or "FADE ALL".
Press RECORD (15) to confirm your operation, and ESC (16) to cancel or exit.
Display mode (100/255)
Enter the setting mode and choose item "4. DISPLAY MODE", then press the RECORD button (15) to enter.
LCD will show you:
1. CF-CARD
2. ASSIGN CH.
1. READ FROM CF
2. STORE TO CF
1. READ FROM CF
2. STORE TO CF
CHANNEL1 > OUT1
OK ESC SEL ADJ
FIXTURE1: ONLY
OK ESC SEL ADJ
DISPLAY MODE : X X X
OK ESC CHANGE
28/30 00028844.DOC, Version 1.0