Ordering Your Analog Line In North America - Dialogic Diva BRI-2FX Installationshandbuch

Information to obtain when ordering
Obtain the following information when you place your order. You will need this
information to properly configure your Dialogic
• The type of ISDN switch your line is connected to.
• Directory number assigned to the T1 line.
• Number of DNIS (Dialed Number Identification Service) digits provided by
your service provider. Normally, you can choose between four, seven, or
ten digits.

Ordering Your Analog Line in North America

This chapter will assist you in ordering an analog line for your Dialogic
Analog Media Board.
Line types
Diva Analog Media Boards can be configured to support a standard analog
line. Specify the following requirements when you place your order:
• Standard analog line
• Loop start line
• Dial type: Diva Analog Media Boards support tone and pulse dialing. It is
recommended to specify tone as the dial type.
Connecting to a PBX
In most installations, the analog line is connected to a PBX instead of the Diva
Analog Media Board. If this is the case and you wish to do DTMF collection
through the PBX, you need to configure the sequence on the PBX as follows:
• Ring voltage
• 500 ms pause
• Routing through DTMF
• 500 ms pause
• Open the call path
Dialogic® Diva® Media Board Installation Guide
® ®
Diva PRI Media Board.
® ®
Diva
page 21