Herunterladen Inhalt Inhalt Diese Seite drucken

Line Provisioning And Configuration For Dialogic Diva Pri Media Boards; Ordering Your Isdn Pri Or T1 Line In North America - Dialogic Diva BRI-2FX Installationshandbuch

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Line Provisioning and Configuration for Dialogic® Diva® PRI Media Boards
Line Provisioning and Configuration for
®
Dialogic
Diva
During the software installation, select the switch type as specified by your
service provider, e.g., Euro-ISDN (ETSI). This will set all line parameters to a
default value that is the most common value for the respective switch type.
In some countries the parameter value is different than the default. For the
Euro-ISDN (ETSI) switch type for example, the CRC 4 mode is normally on,
so the default will set the parameter CRC 4 Mode to ON. However, the CRC
setting needs to be OFF for Energis lines in the UK and Telecom Eireann lines
in the Republic of Ireland. Normally, lines in France, Belgium, and the
Netherlands are also provisioned with the CRC 4 mode OFF.
Please make sure that you configure the value as required by your service
provider. For detailed information, see the Dialogic
Manager Online Help (DSMain.chm) for Windows
®
®
Dialogic
Diva
System Release LIN Reference Guide for Linux.
Note: Your service provider will deactivate your line if you connect to it with
wrong settings. Always contact your service provider to ask for your line to
be reactivated before testing with new settings.

Ordering Your ISDN PRI or T1 Line in North America

This chapter will assist you in ordering an ISDN PRI or a T1 line for your
®
®
Dialogic
Diva
PRI Media Board. It provides recommended settings for a
number of the configuration settings on Diva PRI Media Boards. You should
specify these settings when you order your line from your service provider.
Line types
Diva PRI Media Boards can be configured to support an ISDN PRI line or a T1
line.
ISDN PRI
In North America and Japan, an ISDN PRI line typically supports 23 B-channels
and one D-channel. PRI configurations are used to receive multiple,
simultaneous ISDN calls from analog-modem and digital-services dial-in
traffic. Another common use of ISDN PRI is to connect a PBX (Private Branch
Exchange) to a central office switch.
page 18
®
PRI Media Boards
®
®
Diva
Configuration
®
operating systems and the

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis