Maintenance And Cleaning; What If There Are Problems; Disposal - Beurer MP 48 Gebrauchsanweisung

1. Place the device on a firm, level and dry surface. Ensure that the fan on the bottom and the side air
vents are NOT covered!
2. Insert the mains adapter into a suitable socket according to the technical data on the mains adapter.
3. Insert your hand/foot with the nails treated with UV/LED nail gel into the open-
ing of the device (with the nails facing upwards).
4. Press the ON/OFF button to switch on the nail dryer.
5. Select the desired application duration (30, 60 or 120 seconds) using the ON/
OFF button. Set the application duration according to the recommended set-
ting time of the UV/LED nail gel manufacturer. The device then switches off
automatically after the programmed setting time has been reached. Dry your
treated nails on the other hand/foot as described in this chapter.
Press the ON/OFF button once
Press the ON/OFF button twice
Press the ON/OFF button 3 times
Press the ON/OFF button 4 times
6. Pull the mains adapter out of the socket after each use. Allow the nail dryer to cool down completely.
6� Maintenance and cleaning
WARNING
Before beginning cleaning, pull the mains adapter out of the socket!
• Carefully clean the bottom of the device interior with a damp cloth after each use.
• Do not use any cleaning agents or solvents.
7� What if there are problems?
Problem
Nail dryer cannot be
switched on.
UV/LED nail gel
does not set.
8� Disposal
For environmental reasons, do not dispose of the device in the household waste at the end of its useful life.
Dispose of the device at a suitable local collection or recycling point. Dispose of the device in ac-
cordance with EC Directive – WEEE (Waste Electrical and Electronic Equipment).
If you have any questions, please contact the local authorities responsible for waste disposal.
Application duration = 30 seconds
ON/OFF button lights up blue
Application duration = 60 seconds
ON/OFF button lights up green
Application duration = 120 seconds
ON/OFF button lights up red
The nail dryer turns off
Possible cause
Mains adapter not plugged in
Female connector not inserted
No voltage at mains socket
Set application duration too
short
Solution
Plug the mains adapter into the socket.
Check that the female connector is positioned
correctly.
Check your fusebox.
Set a longer application duration on the nail
dryer. Set the application duration according to
the recommended setting time of the UV/LED
nail gel manufacturer.
10