Bosch PLR 25 Originalbetriebsanleitung Seite 25

OBJ_BUCH-2646-002.book Page 25 Monday, June 27, 2016 12:58 PM
The first measured value is shown at the top of the display.
After the second measurement has been completed, the area
24.589 m
will be automatically calculated and displayed. The end result is
24.589 m shown at the bottom of the display, while the individual meas-
ured values are shown above it.
604.62 m
2
Volume Measurement
Select the volume measurement function
Then measure the width, length and height one after the other as with a length meas-
urement.The laser beam remains switched on between the three measurements. The
distance to be measured flashes in the indicator for volume measurement
After the third measurement has been completed, the volume
will be automatically calculated and displayed. The end result is
24.589 m
shown at the bottom of the display, while the individual meas-
24.589 m
ured values are shown above it.
24.589 m
14866.9 m
3
Continuous Measurement (Tracking) (see figure C)
For continuous measurements, the measuring tool can be moved relative to the tar-
get, whereby the measuring value is updated approx. every 0.5 seconds. In this man-
ner, as an example, you can move a certain distance away from a wall, while the actual
distance can always be read.
Select the continuous measurement function
Press the measuring button 4 to initiate the measuring process.
Move the measuring tool until the desired distance value is
22.589 m
shown in the display below.
min
24.589 m
Pressing the measuring button 4 will interrupt the continuous
max
measurement. The current measured value will be shown at the
23.000 m
bottom of the display. The largest and smallest measured value
appear above it. Pressing the measuring button once more 4
starts the continuous measurement again.
Continuous measurement automatically switches off after 4 mins.
Bosch Power Tools
English | 25
.
.
1 609 92A 23Y | (27.6.16)
.