Lttuploadparameters - LTT -184-8ch Referenzhandbuch

LTTUploadParameters

Declaration:
long __stdcall LTTUploadParameters( void );
Description:
Checks and sends the parameters to the LTT devices.
The parameters have been gathered using LTTAnalogChannel,LTTSampleTime,
LTTRAMBufferSetting, etc. but the device has not yet been configured.
LTTUploadParameters makes a final check to see if the combination of all the
parameters don't make an error and then if successful configures the devices. The
error codes are additive.
Input:
Return:
The return value is a sum of the following error codes.
0 Everything OK
-1 LTT device not found or ASPI dll not found
-2 Wrong sample rate by current channel setting
-4 No channels active
-10 Wrong channel combination!! When backside channels used,
at least one front channel must be active also!
-20 Trigger channel not active
-40 pretrigger settings wrong - no channel set
-100 pretrigger settings wrong - invalid pretrigger length
-200 No Buffer settings specified!!
-400 amount of active channels does not fit channel parameter in buffer
settings.
-1000 Math error
-2000 No active channel for master device.
-4000 - trigger timer and PRE-trigger are
mutually exclusive settings.
-10000 - trigger timer too small;
condition: timer > 4 * sampletime
Beschreibung der DLL LTT2API 65
[Device]
Handbuch Version 3.11