Introduction; Connections, Operating And Display Elements - Cameo D. FORCE 3000 RGB LASER Bedienungsanleitung

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.

INTRODUCTION

PROFESSIONAL SHOW LASER WITH R, G AND B DIODE LASERS
CLLDFORCE3000RGB
CONTROL FUNCTIONS:
ILDA
FEATURES:
Professional show laser. Dust-proof aluminium casing for minimum maintenance. 30 kpps high-speed galvo scanner @ 8° ILDA. Analogue
modulation for up to 16 million colour shades. Precise beams with extremely low divergence for razor-sharp projections. Control via ILDA.
Scan Fail Safety system with deactivation function (prevents emission of a dangerous spot beam). Neutrik powerCON mains input and
output. Low-noise fan for controlled operating temperature. Operating voltage
100–240 V AC Power consumption 110 W.

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS

1
MOUNTING BRACKET
Mounting bracket with attachment holes.
2
CLAMP
Clamp with angle-adjustable lever to clamp the mounting bracket.
3
LASER EMISSION WINDOW
DO NOT look directly into the laser beam! Risk of injury and blinding!
4
LASER EMISSION
The LED indicator lights up as soon as a laser beam is emitted from the laser emission window.
5
COVER PANEL
Adjustable cover panel with knurled screws to limit the output range of the laser as required. Check the cover panel regularly to make sure
it is in the correct position and take care to ensure that the position cannot change even if the device is exposed to heavy vibrations.
1
4
3
2
8
6
5
7
8
2
5