Storage; Frost Protection; Maintenance And Care; Troubleshooting - Kärcher K 6.600 Bedienungsanleitung

Storage

Caution
In order to prevent accidents or injuries,
keep in mind the weight of the appliance
when selecting a storage location for it (see
Specifications).
Storing the Appliance
 Park the machine on an even surface.
 Wind the entire high pressure hose onto
the hose drum by rotating the hand
crank counter-clockwise.
 Insert the trigger gun with the spray
lance into the holder for the trigger gun.
Illustration
 Stow away the mains cable, the high-
pressure hose and accessory on the
appliance.
Option
Pull on the mains cable briefly.
The mains cable is coiled automatically.
Prior to extended storage periods, as dur-
ing the winter, also observe the instructions
in the Care section.

Frost protection

Caution
Protect the appliance and its accessories
against frost.
The appliance and its accessories can get
destroyed through frost if there is any water
residues in them. To avoid damage to
them:
 Completely drain all water from the ap-
pliance:
Detach spray lance from the trigger
gun.
Switch the appliance on ("I/ON"), press
the trigger gun lever until no further wa-
ter is discharged (approx. 1 min).
Turn off the appliance.
 Store the appliance and the entire ac-
cessories in a frost free room.

Maintenance and care

Danger
Turn off the appliance and remove the
mains plug prior to any care and mainte-
nance work.
Prior to longer periods of storage, e.g. in
the winter:
Illustration
 Pull out the sieve in the water connec-
tion using flat-nose pliers and clean un-
der running water.
The appliance is maintenance free.
Use only original KÄRCHER spare parts.
You will find a list of spare parts at the end
of these operating instructions.

Troubleshooting

You can rectify minor faults yourself with
the help of the following overview.
If in doubt, please consult the authorized
customer service.
Danger
Turn off the appliance and remove the
mains plug prior to any care and mainte-
nance work.
Repair works may only be performed by the
authorized customer service.
Appliance is not running
 Pull on the lever of the trigger gun; the
device will switch on.
 Check whether the voltage indicated on
the type plate corresponds to the volt-
age of the mains supply.
 Check the mains connection cable for
damages.
– 11
EN
Care
Maintenance
Spare parts
21