Installation - Klarstein 10030847 Anleitung

1. Place the fireplace on the floor as per the upper arrowhead on the outer carton direction. Remove the
bagging with knives, and open the outer carton.
2. Take out the bag, which includes homeowner manual, remote control, L shape metal and self tapping
screws for installation.
3. Read the homeowner manual carefully, and take out the cover foam with your hands.
4. Lift the insert from the carton, place it on the flat floor, and remove the plastic bag.
5. Fix on the L shape metal in the middle of the bottom of rear of the insert as shown in figure:
6. Put the electric insert with L shape metal into the decorative mantel.
7. Fasten the mantel & insert with two self tapping screws at the bottom of the mantel.
8. After Installation, loose the supply cord, and get the product energized. The plug has been set by the
standards of your country.
9. Whan there is electricity, open the cover box at the bottom of the front of the insert, and tum on the
power switch. You can hear „BEEP" at the same time, which means the insert has been energized.
It Is under normal operation. If there Is no „BEEP", it means there is something wrong with the insert.
Please contact with the supplier in time. NOTE: The models with mechanical control have no „BEEP".
10. The minimum distance from mantel toflreplace body Is 7.8 cm. The minimum distance from fireplace
body to the wall is 13.7 cm.

Installation

1 Self tapping screws
2 Back panel of firebox
3 L shape metal
4 Back panel of firebox
28