Electrolux GA 55 LVSW Benutzerinformation Seite 18

18 www.electrolux.com
Problem/alarm code
The appliance does not fill
with water.
The display shows the
alarm code
The appliance does not
drain the water.
The display shows the
alarm code
The anti-flood device is on.
The display shows the
alarm code
Once the controls have been done,
deactivate the appliance and wait 5
minutes before activating it again. If the
problem persists or the alarm code
continues to appear, contact an
Authorised Service Centre.
When you contact the
Service Centre always
remember to give the alarm
code (when available).
12.2 Poor washing results
• The baskets have been overloaded.
• Tableware has not been properly
arranged.
• The quantity of detergent was not
enough.
• The detergent was not suitable or old.
• The programme was not appropriate
for the degree of soil and the type of
load.
• The spray arms were blocked by the
tableware and could not rotate freely.
• The spray arms are clogged.
• The filters are clogged or not
positioned correctly.
• The selected level of the water softener
is not appropriate for the hardness of
your water supply.
Possible solution
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not
too low. For this information, contact your local water
authority.
.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not clog-
ged.
• Make sure that the inlet hose has no kinks or bends.
• Make sure that the sink spigot is not clogged.
• Make sure that the filter in the outlet hose is not clog-
ged.
• Make sure that the drain hose has no kinks or bends.
.
• Close the water tap and contact an Authorised Service
Centre.
.
12.3 Poor drying results
• Tableware has been left too much time
inside a closed appliance.
• The selected programme has no drying
phase.
• The selected programme has a drying
phase with low temperature.
• The dosage of rinse aid is not enough.
Set the rinse aid dispenser to a higher
level.
• There is no rinse aid in the rinse aid
dispenser.
• Plastic items may need to be towel
dried.
• Dishes have not been arranged
properly in the baskets.
• Arrange the tableware avoiding, if
possible, contact points. This will allow
water to reach all surfaces.
• Arrange kitchen utensils in a sloping
position.
• The interior of the appliance is wet
caused by the humidity in the air that
condenses on the inner sides of the
appliance. This is not a defect of the
appliance.
• Multi-tablets may give poor drying
results. Try a different brand of multi-
tablets. The use of rinse aid together
with multi-tablets can help to increase
drying performance.