Inhaltsverzeichnis
Werbung
Fræsning
Fig. 7
Materiale
Stål
Aluminium,messing
Plastic
4. VEDLIGEHOLDELSE
Sørg for at maskinen ikke står under strøm, når der udføres
vedligeholdelsesarbejder på mekanikken.
Maskinerne fra Ferm er udviklet til at fungere længe uden problemer med et minimum af
vedligeholdelse. Ved at rengøre maskinen regelmæssigt og behandle den korrekt, bidrager
De til en længere levetid for maskinen.
Rengøring
Rengør regelmæssigt maskinkappen med en blød klud, helst efter hvert brug. Sørg for at
ventilationshullerne er fri for støv og snavs. Brug en blød klud, der er vædet i sæbevand til at
fjerne hårdnakket snavs. Brug ingen opløsningsmidler, så som benzin, alkohol, ammoniak,
osv. Den slags stoffer beskadiger kunststofdelene.
Smøring
Maskinen behøver ingen ekstra smøring.
DK
Fejl
Skulle en fejl opstå, f.eks. pga. slidtage af en enhed, kontakt venligst serviceadressen på
garantibeviset. På bagsiden af denne manual finder du en tegning med alle dele, der kan
bestilles.
Miljø
For at undgå transportbeskadigelse leveres maskinen i en solid emballage. Emballagen er så
vidt muligt lavet af genbrugsmateriale. Genbrug derfor emballagen.
Defekte og/eller kasserede elektriske eller elektroniske maskiner skal afleveres på
en genbrugsplads.
Garanti
Læs det separat vedlagte garantikort for garantibetingelserne.
68
Hastighed
5
3
5
Ferm
2. SAFETY INSTRUCTIONS
The following pictograms are used in these instructions for use:
Read instructions carefully
In accordance with essential applicable safety standards of European directives
Class II machine – Double insulation – You don't need any earthed plug.
Denotes risk of personal injury, loss of life or damage to the tool in case of non-
observance of the instructions in this manual.
Indicates electrical shock hazard.
Immediately unplug the plug from the mains electricity in the case that the cord
gets damaged and during maintenance
Faulty and/or discarded electrical or electronic apparatus have to be collected at
the appropriate recycling locations.
Special safety instructions
•
Always keep the cord away from the moving parts of the machine.
•
In the case of locking, switch the machine off immediately and remove the plug from the
mains.
•
Compare the maximum number of revolutions allowed of the accessories with the
number of revolutions of the machine.
•
When you put the machine away the engine must be switched off and moving parts must
have reached a standstill.
•
Never attach an assembly spanner to your machine with a piece of string or anything
similar.
•
Never use the axle locking button if the machine is operating.
•
Make sure that the spring chuck diameter is the same as the axle diameter of the
accessory.
•
Use a clamping device for securing the work piece.
•
Keep your hands away from the work piece.
Electrical safety
When using electric machines always observe the safety regulations applicable in your
country to reduce the risk of fire, electric shock and personal injury. Read the following safety
instructions and also the enclosed safety instructions. Keep these instructions in a safe place!
Ferm
GB
05
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
