Herunterladen Inhalt Inhalt Diese Seite drucken

Hendi 272701 Gebrauchsanweisung Seite 16

Vorschau ausblenden Andere Handbücher für 272701:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 22
Assemble all nuts and bolts loosely at first. Tighten all connections after
completion of assembly. This eases your work and increase the stability
of your appliance.
Before assembly, make sure all protection packing material must be
moved.
Small deviations in equipment may occur. This is no lack of quality but
subject to improvements.
ASSEMBLY
STEP 1:
Screw rear panel of housing to the base with 5pcs bolts M5 x 10 and
5pcs washer. (Detail Abb. A)
STEP 2:
Push the housing lid over rear panel of housing and place onto rear
panel of housing. Screw together the housing lid and rear panel of
housing with 5pcs bolts M5 x 10 and 5pcs washers. (Detail Abb. B)
STEP 3:
(272602)Fixing the post upwards onto the housing lid with 4pcs bolts
M5 x 10 and 4pcs washers, then put plastic cover through the post.
(Detail Abb. D)
(272701) Hold base&housing assembly declining by one hand and
insert the bottom end of main post through base hole by the other
hand. Put the top end of post across the central hole of housing lid and
set free base&housing assembly on flat floor. (Detail Abb. C)
Note: Loose the plastic screw a bit if it feels too tight to pull up
the main post.
STEP 4:
(272701 only) Pull up the main post until it encounters housing lid.
Keep the main post lifted and turn until it is tracked up. Turn the main
post anticlockwise until it gets stuck. Press it down and tighten the
plastic screw of retractable device. (Detail Abb. D)
STEP 5:
Place the reflector to main burner using 3pcs wing nuts and 3pcs
washers. (Detail Abb. E)
STEP 6:
Then fix main burner to the post with 3 bolts M5 x 10 and 3pcs
washers. (Detail Abb. F)
STEP 7:
Fix the door to housing. (See Figure 2 and Detail Abb. G)
STEP 8:
Attach 3pcs stands to the base. (Detail Abb. H)
Use nails or raw bolts which depending on the type of patio floor to fix
the base to the ground. (See Figure 3)
STEP 9:
Collect the wheels parts together and fix the wheels to the base. (See
Figure 4)
Figure 3
Figure 4
Detail B
Detail C
Detail D
Detail E
Detail F
Detail G
Detail H
8
16

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

272602

Inhaltsverzeichnis