FALMEC LUMINA NRS-HORIZON Bedienungssanleitung Seite 32

Phase 2
(Fig. C)
- In case of exhaust version, connect the output fitting of the fan to the external exhaust (F)
following the indications in fig. C.
1) Measure the quota X as indicated in fig.C detail1.
2) Cut the NRS pipe (A) according to the indication in fig.C detail 2.
3) Cut the NRS elbow (B) according to the indications in fig.C detail 3 so that the exhaust pipe
(A) is installed perfectly vertical.
(Fig. D)
1-2-3-4) Fasten the flange (C) at the exhaust hole (F) with the 3 screws V3.
(Fig. E)
1) Carefully insert the pipe (A) in the motor fitting (D);
2) Fasten the pipe (A) to the hood body with the 3 screws (V4).
3) Insert the elbow (B) onto the pipe (A) and flange (C).
4) Secure the elbow (B) to the pipe (A) with a clamp and bend the flaps of the flange (C) as
indicated in the figure.
- Carry out the electric connection only after having disconnected the electric power supply
of the hood.
Phase 3
(Fig. F)
1) Insert the extension (H) in the chimney (G).
2) Fasten it all (G+H) to the hood body using the screws (V5).
3) Slide the extension (H) until it reaches the desired height.
4) Place the bracket (L) on the wall, verify the horizontal alignment with a spirit level and mark
2 drilling points at the ends.
5) Drill, insert 2 ø 4mm expansion plugs and fasten the bracket (L) with the relative screws
(V6).
6) Screw the extension (H) to the bracket (L) using the two screws (V7).
- Power the hood complying with the regulations in force (see sec. D of the booklet).
INSTRUCTIONS FOR ISLAND-MOUNTING OF HORIZON NRS, LUMINA
N2
NRS, PLANE NRS, VELA NRS HOODS
Phase 1
(Fig. A1)
- Identify the height H of the cooker resulting from the sum of the quotas: X + Y + H1
(Fig. B1)
- Following the indications in sec. H1, remove the perimeter suction panel (AP) (if present)
and the metal filters. Only for the Lumina NRS Island hood, remove the front panel (PN).
- Disconnect the male connector (CO) from the matching female connector fastened to the
hood body.
(Fig. C1)
- Loosen the 4 screws securing the NRS motor chamber (CM);
- shift the NRS motor chamber (CM) sideways to position the 4 screws against the hole
instead of the slot;
- lift the motor chamber (CM) upwards to remove it from the hood body.
(Fig. D1)
- Fasten the element (TI) to the NRS motor chamber (CM) with the 7 screws (V1).
(Fig. E1)
- Fasten the top trellis (TS) to the ceiling using the 4 Ø 8 plugs and relative screws (V2).
30