FALMEC LUMINA NRS-HORIZON Bedienungssanleitung Seite 33

(Fig. F1 and G1)
- Measure the quota "Z" as indicated in figure F1.
- Cut the NRS pipe (A) and the NRS elbow (B) according to the indications in figure F1 part 2
so that the exhaust pipe (A) is installed perfectly vertical. Fasten the NRS elbow (B) to the
NRS pipe (A) with a clamp and connect it all temporarily to the exhaust pipe (F) set up on
the false ceiling or loft.
- Slide the whole set (CM+TI) on the trellis (TS) until reaching the desired height (H1) (also
see fig. A1)
- Secure the components (CM+TI and TS) with the 8 self-threading screws (V3).
Phase 2
(Fig. H1)
- Carefully insert the NRS pipe (A) in the motor fitting (D) of the motor chamber (CM) and
fasten it with 3 screws (V7).
(Fig. I1 and L1)
- Fasten the extension support elements (SP) to the trellis (TS) on the false ceiling or to the
motor chamber (CM) if the trellis (TS) is not used.
- Insert the chimney (G) onto the extension (H) and fasten them together with paper adhesive
tape.
- Insert the chimney-extension set (G+H) in the motor body (CM).
- Fasten the chimney-extension set (G+H) to the extension support elements (SP) or onto the
top trellis TS with the 4 metric screws M4 (V5) without screwing them all the way.
(Fig. M1)
- Lift the hood body so that its lower holes are centred on the 4 M5 metrics screws of the
motor chamber (CM). Shift the motor chamber (CM) sideways so that the metric screws are
positioned on the slots and then tighten them permanently.
Phase 3
(Fig. N1)
- Remove the paper tape, unscrew the 4 M4 metric screws (V5) previously screwed onto the
extension support elements (SP) and slide the chimney-extension set (G+H) downwards.
- Perform the following connections:
EXHAUST -> NRS pipe + elbow (A+B) to exhaust pipe (F). For the filter version (see sec. F)
the air exhaust must be directed towards the extension slots.
ELECTRIC (only after having disconnected power).
- Fasten the extension (H) once again to the extension support elements (SP) with the 4 M4
metric screws (V5).
- Slide the chimney (G) downwards and fasten it to the hood body with the self-threading
screws (V6).
- Reconnect the male connector (CO) to the matching female connector fastened to the hood
body.
- Following the indications in sec. H1, reassemble the metal filters and the eventual perime-
ter suction panel (AP). In the case of the Lumina NRS Island hood, reassemble the front
panel (PN).
- Power the hood complying with the regulations in force (see sec. D of the booklet).
31