iwc TRIBUTE TO PALLWEBER Bedienungsanleitung Seite 11

— 1 8 —
F U N C T I O N S O F T H E C R O W N
Normal position
0 —
Time setting
1 —
N O R M A L P O S I T I O N
With the crown in the normal position (0), you can wind the watch
by turning the crown clockwise. Always wind the watch fully, to
the point at which you feel a distinct resistance in the crown. Your
watch has a power reserve of approximately 60 hours. To ensure
maximum accuracy, you should fully wind your watch every day
as a matter of routine. The crown must always be in position 0
when you are wearing your watch.
I W C T R I B U T E T O PA L LW E B E R
0 1
— 1 9 —
T I M E S E T T I N G
Pull out the crown to position 1. This will stop the movement.
You can then set the current time by slowly turning the crown
to the right or the left. To start the seconds hand, push in the
crown to position 0.
I N F O R M AT I O N A B O U T M AG N E T I C F I E L D S
As a result of the ever greater prevalence in recent years of very
strong magnets made from rare­earth alloys (e.g. neodymium­
iron­boron) – these are found in objects such as loudspeakers,
mobile phones and fasteners on jewellery as well as handbags –
mechanical watches are increasingly likely to come into contact
with such magnets and become magnetized. This can lead to
the watch rate being permanently affected, a problem that can
only be resolved by a process of demagnetization carried out
by a specialist. We recommend that you keep your watch away
from such magnets.
Watches with a soft­iron inner case provide a higher level of
protection against magnetic fields and far exceed the require-
ments of DIN standard 8309. Nevertheless, it is still possible for
the watch movement to become magnetized in close proximity
I W C T R I B U T E T O PA L LW E B E R