Electrical Warnings - IKEA MATÄLSKARE Bedienungsanleitung

ENGLISH
INSTALLATION
The appliance must be handled and
installed by two or more persons - risk of
injury. Use protective gloves to unpack and
install - risk of cuts.
Installation, including water supply (if any)
and electrical connections, and repairs must
be carried out by a qualified technician. Do
not repair or replace any part of the appliance
unless specifically stated in the user manual.
Keep children away from the installation site.
After unpacking the appliance, make sure that
it has not been damaged during transport.
In the event of problems, contact the dealer
or your nearest After-sales Service. Once
installed, packaging waste (plastic, styrofoam
parts etc.) must be stored out of reach of
children - risk of suffocation. The appliance
must be disconnected from the power supply
before any installation operation - risk of
electrical shock. During installation, make sure
the appliance does not damage the power
cable - risk of fire or electrical shock. Only
activate the appliance when the installation
has been completed.
This appliance is intended
to be used built-in. Do not use
it freestanding or place into a
cabinet.
After unpacking the appliance, make sure that
the appliance door closes properly.
In the event of problems, contact the dealer or
your nearest After-sales Service.
Carry out all cabinet cutting works before
fitting the appliance in the furniture and
remove all wood chips and sawdust.
Do not obstruct the minimum gap between the
worktop and the upper edge of the oven - risk
of burn.
Do not remove the oven from its polystyrene
foam base until the time of installation.
After installation, the bottom of
the appliance must no longer be
accessible - risk of burn.

ELECTRICAL WARNINGS

The rating plate is on the front
edge of the oven (visible when the
door is open).
It must be possible to
disconnect the appliance from
the power supply by unplugging
it if plug is accessible, or by a
multipole switch installed upstream
of the socket and the appliance
must be earthed, in conformity
with national electrical safety
standards.
Do not use extension leads, multiple
sockets or adapters. The electrical components
must not be accessible to the user after
installation. Do not use the appliance when
you are wet or barefoot. Do not operate this
appliance if it has a damaged power cable
or plug, if it is not working properly, or if it has
been damaged or dropped.
If the supply cord is damaged,
it must be replaced with an
identical one by the manufacturer,
its service agent or similarly
qualified persons in order to avoid
a hazard - risk of electrical shock.
In case of replacement
of power cable, contact an
authorized service center.
6