Electrical Warnings - IKEA KULINARISK Bedienungsanleitung

ENGLISH
Installation, including water supply (if
any) and electrical connections, service or
repair operation that involves the removal of
a cover which gives protection against
exposure to microwave energy (if any) and
repairs must be carried out by the
authorised installer. Follow the assembly
instructions supplied with the appliance.
Remove all the packaging. Make sure that
the appliance has not been damaged during
transport. In the event of problems, contact
the dealer or your nearest Authorised
Service Centre. Do not install or use a
damaged appliance.
Install the appliance in a safe and
suitable place that meets installation
requirements. Do not use the appliance
before installing it in the built-in structure.

Electrical warnings

Risk of fire and electric shock.
Make sure that the parameters on the
rating plate are compatible with the
electrical ratings of the mains power supply.
Do not use extension leads, multi-plug
sockets or adapters. Do not operate the
appliance if it has a damaged power cable or
plug, if it is not working properly, or if it has
been damaged or dropped. The appliance
must be earthed. Always use a correctly
installed shockproof socket. The shock
protection of live and insulated parts must
be fastened in such a way that it cannot be
removed without tools. The electrical
components must not be accessible to the
user after installation.
The electrical installation must have an
isolation device which lets you disconnect
the appliance from the mains at all poles.
The isolation device must have a contact
opening width of minimum 3 mm. Use only
correct isolation devices: line protecting
cutouts, fuses (screw type fuses removed
from the holder), earth leakage trips and
contactors.
To download the full version visit www.ikea.com
Do not pull the appliance by the handle.
Keep the minimum distance from other
appliances and units. Before mounting the
appliance, check if the oven door opens
without restraint.
Ensure that the appliance is switched off
and disconnected from the power supply
before performing any maintenance
operation - risk of electric shock. During
installation, make sure the appliance does
not damage the power cable - risk of fire or
electric shock. Only activate the appliance
when the installation has been completed.
Do not obstruct the minimum gap
between the worktop and the upper edge of
the oven - risk of burns.
Connect the mains plug to the mains
socket only at the end of the installation.
Fully close the appliance door before you
connect the mains plug to the mains socket.
Make sure that there is access to the mains
plug after the installation. If the mains
socket is loose, do not connect the mains
plug. Do not pull the mains cable to
disconnect the appliance. Always pull the
mains plug. Do not let mains cables touch or
come near the appliance door or the niche
below the appliance, especially when it
operates or the door is hot.
To replace the power cable, contact the
Authorized Service Centre.
This product contains a light source of
energy efficiency class G.
Concerning the lamp(s) inside this
product and spare part lamps sold
separately: These lamps are intended to
withstand extreme physical conditions in
household appliances, such as temperature,
vibration, humidity, or are intended to signal
information about the operational status of
the appliance. They are not intended to be
7