Check the vacuum bar setting
Press the switch of the suction turbine;
the vacuum process will start.
Lower the vacuum bar.
Push the appliance forward a bit.
Switch off suction turbine switch.
Adjustment of the vacuum bar, adjust if
necessary.
Setting the Vacuum Bar
Loosen the nut.
Move the wheel upwards or down-
wards.
Tighten nut.
Check the setting of the vacuum bar.
Replacing the disk brushes
Tilt the appliance rearward.
Use both hands to pull the disc brush to
the cleaning head.
Turn the disk brush by approx. 45° in
anti-clock-wise direction (viewed from
above).
Remove the disk brush at the bottom.
Insert new disk brush in reverse se-
quence.
22
Clean the fresh water filter
1 Filter inlay
2 Filter pot
Unscrew the filter cup.
Take out the filter inlay.
Rinse the filter inlay with clear water.
Install a new filter inlay.
Install and tighten filter pot.
Replacing fuses
1 Suction hose
2 Screw
3 Main fuse, 30 A, green
Loosen screws.
Remove cover.
Test the fuses, if necessary replace
with new fuses of the same capacity.
– 7
EN