Mounting Batteries; Mounting; Operation Smartcore Batteries - Lupine BLIKA Bedienungsanleitung

Mounting Batteries

Battery mounting:
Your battery is supplied
with a velcro strap, coated
with an anti-slip material
to ensure a secure mount.
Use the strap which most
closely matches your tube
size.
Battery type:
The regular battery is mounted
with a velcro as shown here and
on page 24. So called Smartcore
batteries also come with a capacity
indictator as explained on the next
page.
13.2Ah
FastClick batteries dont have a loop for a
velcro.
However they can be directly put into the
clicksystem of the FastClick headbelt or 3M
clicksystem.
28 Blika
6.6Ah 3.3Ah 3.3Ah
Operation SmartCore battery
Capacity Indicator
Audible:
To check the capacity, simply press the
touch-pad once. At fi rst an audible signal
will sound, which is especially useful
while using the battery mounted on a
helmet or headband, to give a quick
reading in 20% steps.
Visible:
The visible indicator uses 5 red LEDs. The LEDs can operate in two
diff erent operating states: blinking and continuous. LED meanings:
A blinking LED is indicating a 10% step and a continuously glowing
LED a 20% step.
Example: 3 LEDs steady glow (20 %, 40 %, 60 %)
1 LED blinking (80 %) = 70 % remaining capacity
Taillight
To run the taillight simply press the touch pad two times
operate continuously. To switch off the taillight, simply press the pad again.
Moving light:
Press the touch pad three times to activate the moving light. To switch it off
press the button another time.
5 x 5 x = 100 % = 100 %
4 x 4 x = 80% = 80%
3 x 3 x = 60% = 60%
2 x 2 x = 40% = 40%
1 x 1 x = 20% = 20%
and the 5 LEDs will
Blika 29