Mounting Batteries - Lupine Betty R Bedienungsanleitung

2

Mounting Batteries

Mounting:
Your battery is supplied with
both a short and a long Velcro
strap, coated with an anti-slip
material to ensure a secure
mount. Use the strap which
most closely matches your
tube size.
32 Betty R
For a demonstration of how to mount the
battery on a bicycle frame, see the video
on our Website (click "Support").
Capacity Indicator:
Audible:
To check the capacity, simply press the
5 x
touch-pad once. At first an audible sig-
4 x
nal will sound, which is especially useful
3 x
while using the battery mounted on
2 x
a helmet or headband, to give a quick
1 x
reading in 20% steps.
Visible:
The visible indicator uses 5 red LEDs. The LEDs can operate in two different
operating states: blinking and continuous. LED meanings:
is indicating a 10% step and a continuously glowing LED a 20% step.
Example: 3 LEDs steady glow (20 %, 40 %, 60 %)
1 LED blinking (80 %)
Taillight
To run the taillight simply press the touch pad two times
operate continuously. To switch off the taillight, simply press the pad again.
Moving light:
Press the touch pad three times to activate the moving light. To switch it off
press the button another time.
Note: The capacity indicator will fade out within a few seconds. If it does not,
eventually the taillight was activated and the 5 glowing LEDs do by far not
mean the battery is fully charged.
Operation
= 100 %
= 80 %
= 60 %
= 40 %
= 20 %
A blinking LED
= 70 % remaining capacity
and the 5 LEDs will
Betty R
3
33