Mounting Batteries - Lupine Betty R 7 Bedienungsanleitung

2

Mounting Batteries

Your battery is supplied with
both a short and a long Velcro
strap, coated with an anti-slip
material to ensure a secure
mount. Use the strap which
most closely matches your
tube size.
32 Betty R
1
For a demonstration of how to mount the
battery on a bicycle frame, see the video
on our Website (click "Support").
Capacity Indicator:
2
Audible:
To check the capacity, simply press the
touch-pad once. At fi rst an audible sig-
nal will sound, which is especially useful
while using the battery mounted on
a helmet or headband, to give a quick
reading in 20% steps.
Visible:
The visible indicator uses 5 red LEDs. The LEDs can operate in two diff erent
operating states: blinking and continuous. LED meanings:
is indicating a 10% step and a continuously glowing LED a 20% step.
Example: 3 LEDs steady glow
1 LED blinking
Taillight
To run the taillight simply
operate continuously. To switch off the taillight, simply press the pad again.
Moving light:
Press the touch pad three times
press the button another time.
Note: The capacity indicator will fade out within a few seconds. If it does not,
eventually the taillight was activated and the 5 glowing LEDs do by far not
mean the battery is fully charged.
5 x = 100 %
4 x = 80 %
3 x = 60 %
2 x = 40 %
1 x = 20 %
A blinking LED
(20 %, 40 %, 60 %)
= 70 % remaining capacity
(80 %)
press the touch pad two times and the 5 LEDs will
to activate the moving light. To switch it off
3
Operation
Betty R 33