Hartan Topline S Bedienungsanleitung Seite 20

Instructions
Readjustment of hand brake
Readjust the hand brake by means
of the cable adjusting barrel.
A different brake effect on the two rear
wheels can be corrected by means of
the cable adjusting barrel.
Lock-type-swivel wheels
(only Topline S)
Turn the cap 10 so that the red point
is visible to pre-select the straight-line
motion mode, which will be activated
the moment the wheels point in forward
direction. Turn the cap 10 so that the
green point is visible to release the
swivel lock. To remove the wheel,
release the push-button in the centre
of the cap 10 and pull the wheel off the
holding device. To assemble the wheel,
insert the fastening pin in the holding
device, and depress the push-button
inside the cap, which is indicated by
a click sound.
Adjustable suspension system
By turning the selector 11, a „hard"
or „soft" position can be selected for
suspension.
Automatic lock for upper section
Place the stroller unit upon the chassis in a way that the two lateral pin
engage in the respective slots 18 on each side. Then push the unit right up
to the stop. The catching pins on both sides engage automatically, which
WARNING!
is indicated each time by a click sound. By pulling the
upper section horizontally, check before use whether it is fixed correctly!
If the red safety point can still be seen, the upper-section lock has not
yet completely closed! Pull the green locking lever downwards until
it snaps into place to open the lock. Then remove the upper section.
The stroller unit can be reversed at that.
16