Water Inlet - Electrolux EWC 1350 Benutzerinformation

5. The three holes must then be
plugged with the plastic plug caps
supplied in the bag containing the
instruction booklet, which can be
found inside the drum.
13.3 Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the
machine is not impeded by carpets, rugs
etc. Check that the machine does not
touch the wall or furniture. Level the
washing machine by raising or lowering
the two front feet. If necessary, check the
setting with a spirit level. Any necessary
adjustment can be made with a spanner.
Accurate levelling prevents vibration,
noise and displacement of the machine
during operation.
CAUTION!
Never place cardboard,
wood or similar materials
under the machine to
compensate for any
unevenness in the floor.

13.4 Water inlet

WARNING!
This appliance must be
connected to a cold water
supply.
1. Connect the water inlet hose
supplied with the machine to a tap
with a 3/4" thread. Always use the
hose supplied with the appliance.
If necessary, use the suitable or
supplied restrictor (1/2").
Do not use the hose
from your previous
machine to connect to
the water supply.
2. The machine end of the inlet hose
can be turned in any direction. Set
the hose correctly by loosening the
ring nut. After positioning the inlet
hose, be sure to tighten the ring nut
again to prevent leaks.
ENGLISH 23