Water Inlet Filters; Operating Problems - Electrolux EWT 136451W Handbuch

THE EXTERIOR
Use warm soapy water to clean the exterior
of the appliance. Never use alcohol, sol-
vents or similar products.
DISPENSER BOX
To clean, proceed as follows :
1
2
DRAINAGE FILTER
Clean the filter located at the base of the
appliance regularly :
1

OPERATING PROBLEMS

Numerous checks were carried out on your
appliance before it left the factory. Howev-
er, should you notice a malfunction, please
Problems
The washing machine
doesn't start or doesn't
fill :
The appliance fills but
empties straight away :
The washing machine
doesn't rinse or doesn't
empty :
3
4
3
2
• the appliance isn't plugged in correctly, the electrical installation isn't
working,
• the lid of your appliance and the drum shutters aren't closed firmly,
• the programme start command hasn't been properly selected,
• there is a power failure,
• the water supply has been cut off,
• the water inlet tap is closed,
• the water inlet filters are dirty,
• a red tab appears on the water inlet hose
• the drainage U-piece is fixed too low (see installation section).
• the drain hose is blocked or bent,
• the drainage filter is obstructed,
• the out of balance detector has been activated : washing is unevenly
distributed in the drum,
• the "Drain" programme or "Night Silence Plus" or "Rinse hold" option
have been selected,
• the height of the drainage U-piece is unsuitable.
5
4

WATER INLET FILTERS

To clean, proceed as follows :
refer to the sections below before contact-
ing the after-sales service.
Causes
1)
.
electrolux 23
7
6