Electrolux EWC 1350 Benutzerinformation Seite 19

Authorised Service Centre, please carry
out the checks listed below.
During machine operation it is possible
that the End pilot light blinks to indicate
that the machine is not working:
• 1 flash: problem with the water
supply.
• 2 flashes: problem with the water
draining.
11.2 Possible failures
Problem
The machine does not
start:
The machine does not
fill:
The machine fills then
empties immediately:
The machine does not
empty and/or does not
spin:
• 4 flashes: door open.
Once the problem has been eliminated,
press the button START to restart the
programme. If after all checks, the
problem persists, contact your
Authorised Service Centre.
Possible cause/Solution
The door has not been closed.
• Close the door firmly.
The plug is not properly inserted in the power socket.
• Insert the plug into the power socket.
There is no power at the socket.
• Please check your domestic electrical installation.
The main fuse has blown.
• Replace the fuse.
The selector dial is not correctly positioned and the but‐
ton Start has not been pressed.
• Please turn the selector dial and press the button
Start again.
The water tap is closed.
• Open the water tap.
The inlet hose is squashed or kinked.
• Check the inlet hose connection.
The filter in the inlet hose is blocked.
• Clean the water inlet hose filter.
The door is not properly closed.
• Close the door firmly.
The end of the drain hose is too low.
• Refer to relevant paragraph in «Installation» chapter.
The drain hose is squashed or kinked.
• Check the drain hose connection.
An option or a programme that ends with the water still
in the tub or that eliminates all the spinning phases has
been selected.
• Select the draining or spinning programme.
The laundry is not evenly distributed in the drum.
• Redistribute the laundry.
ENGLISH 19