Operating Instruction BDS 33/190 C, BDS 43/150 C, BDP 43/410 C, BDS 43/Duo C English
Operating the unit
Note:
The unit is kept in position after starting by
rocking the handle slightly up- and down
Direction control
Left
Lower the handle or press down slightly
Right
Raise the handle or pull up slightly
■
Apply cleaning agent solution on
surface to be cleaned or actuate the
dosing lever at the cleaning agent tank
(accessory)
■
Manually guide the unit over the surface
to be cleaned.
■
Do not press the unit onto the surface to
be cleaned. Use additional weight
(accessory) if necessary.
■
Repeat the action if the surface is very
dirty.
■
Then collect the dirty water with a wet
vacuum cleaner or with an absorbent
cloth.
20
Cleaning agent tank (accessory)
Assembly
■
Loosen the screws on the
holders (1 and 2)
■
Hang the cleaning agent tank in the
bottom holder
Note:
Make sure that the cleaning agent tank is
above the engine
■
Fix the cleaning agent tank by moving
the two holders
■
Tighten the screws on the
holders (1 and 2)
■
Insert the hose (3) for feeding the
cleaning agent into the appropriate
hole.