Model slips (drifts) or tilts to the right:
• Reduce the speed and push the trim slider of the roll-function of the
right remote control lever stepwise to the left.
• Push the pitch-lever forward again and check whether the
correction was sufficient, if necessary shift the trim further to the
left.
• Repeat the process until the helicopter no longer shows a tendency
GB
to drift to the right.
Model slips (drifts) forward:
• Reduce the speed and push the trim slider of the nick function on
the right remote control lever stepwise backwards.
• Push the pitch lever forward again and check whether this was
sufficient for correction, if necessary shift the trim further to the left.
• Repeat the process until the helicopter no longer shows a tendency
to drift forwards.
Hover flight
Hover flight means maintaining the helicopter in a stable position
in the air. Hover flight is only possible with a helicopter and must be
thoroughly practiced as a fundamental flight formation.
Acquaint yourself with the control functions of your remote control
transmitter so that this procedure gets you're your "flesh and blood".
• Then set the helicopter about 2 m in front of you on the ground,
with the tail facing you.
• Leave the helicopter on the ground and first deliberately move it
slightly sidewise, forwards and backwards.
• When you have mastered control on the ground, give somewhat
more lift and permit it to hover above the ground, without allowing
the tip of the fuselage to turn or the helicopter to drift away.
• The best procedure is to mark a position on the ground from which
you start the model.
Attempt to hold the helicopter above this position and also to land
again on this position.
• Do not move the control lever too jerkily, because otherwise
especially the touchdown can be very hard. Develop a feeling for
the controls by repeatedly lifting off, floating and landing again.
k. Free Flying Training
The helicopter is no longer in the area of influence of the air
turbulence from its own rotors as of a flying height of about 2 m and
the flight situation is more stable.
36
CARSON Mini Tyrann
Model slips (drifts) or tilts
to the right:
• Proceed as described above, but push
the trim slider of the tail function
stepwise to the right.
Model slips (drifts) backwards:
• Proceed as described above, but push
the trim slider of the nick function
stepwise forward.
• If you notice irregularities in the control or an imbalance in the rotor,
land
immediately
and correct the necessary settings.
• Increase the flying height gradually by degrees.