Accessories - Kärcher CV 85/2 RS Originalbetriebsanleitung

Checking the drive chain
1 Screw
2 Front panel
Loosen screws.
Remove front panel.
Fault
Appliance cannot be started
Device does not drive or drives
only slowly
Device does not brake
Brushes in brush/ vacuum
head are not working
Side-brush is not working
Brushes are rotating slowly
Suction turbine is not working
Poor dust suction
Description
Filter bag, 10 pieces
Battery replacement kit consists of: battery trough, cable set, locking set, 2 transport cars
Battery, 12V/105 A, maintenance-free (gel), 3 pieces required
Charger, 36V, for maintenance-free batteries
1 Screw
2 Cover
3 Drive chain
Loosen screws.
Remove the lid.
Check the chain drive and pinion for
wear.
Remedy
Insert the battery plug on the device.
Release emergency-stop button by turning.
Battery capacity exhausted; recharge battery.
Check battery cable for correct sitting.
Check battery cable for corrosion; clean, if required.
Press the unlocking key.
Reset fuse of traction drive
Deactivate immobilising brake; press the unlocking lever upward to activate it.
Release accelerator pedal, turn the key switch to "0", turn the key switch to "1", press
the safety pedal, press unlocking key, press accelerator pedal.
Control is overheated
Switch off device and let it cool down.
Battery capacity exhausted; recharge battery.
Deactivate immobilising brake; press the unlocking lever upward to activate it.
Reset fuse of brush roller drive.
Check the brushes for blockage due to foreign particles, remove them if found.
Reset fuse of side-brush drive.
Battery capacity exhausted; recharge battery.
Reset fuse of suction turbine.
Battery capacity exhausted; recharge battery.
Filter bag is full; the indicator 'filter bag full' glows. Replace filter bag.
Suction hose/ suction channel blocked; clean suction hose/ suction channel.
Battery capacity exhausted; recharge battery.
Filter bag full; replace filter bag.

Accessories

7
-
EN
Faults
Danger
Risk of injury! Before carrying out any tasks
on the machine, set the main key to "0" and
remove it. Pull out the battery plug.
In case of faults that cannot be remedied
using the table below please contact the
customer service.
Part no.:
8.600-121.0
8.601-121.0
6.654-141.0
6.654-229.0
By whom
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
17