Antenna Settings - Megasat HD 5 Combo Bedienungsanleitung

3. Main Menu

3.1.5 Antenna settings

Satellite
LNB Type
LO.LOW /
LO.HIGH
22k
LNB power
Change type
Change Input
Centre Freq
Motor
Note:
Press the F1 key to start the Auto-DiSEqC function. This must be performed indivi-
dually for each satellite.
12
Displays the current satellite. Use the
the satellite. Press OK to open the satellite list.
Select the LNB type (eg Universal)
Here you can set the LNB low and high frequencies if you have
set "LNB Type" to "Customized".
Set the 22k circuit to AUTO, ON or OFF.
Set the LNB voltage to AUTO, 13V, 18V or OFF.
Select the DiSEqC circuit (1.0 or 1.1)
Select the Unicable system
- Unicable (EN 50494): SCR Port A / B
- Unicable II (EN 50607): SCR Port A / B / C / D
DiSEqC 1.0: Choose between port 1-4
DiSEqC 1.1: Choose between port 1-16
Unicable: Select between IF channel 1-8
Unicable II: Select between IF channel 1-32
Enter the Unicable frequency of the system.
Choose between fixed antenna or motor operation (DiSEqC 1.2
or USALS). If you have selected engine operation, press OK to
enter the settings to adjust the engine.
ENGLISH
buttons to change
t u