Product Description; Installation And Connection - Oase HeatUp 25 Gebrauchsanleitung Und Garantieschein

N O T E
Indicates information intended to give the user
a better understanding.
Additional information
 A Reference to a figure, e.g. Fig. A.

PRODUCT DESCRIPTION

Intended use
HeatUp 25/50/75/100/150/200/250/300, re-
ferred to in the following as "unit", may only be
used as specified in the following:
• As a thermostat controlled aquarium heater.
• Operation under observance of the technical
data.
The following restrictions apply to the unit:
• Only use indoors and for aquaristic purposes
in the home (not for commercial use).
• Only operate with water at a water tempera-
ture of +4 °C to +35 °C.

INSTALLATION AND CONNECTION

N O T E
• Do not switch the unit on until it is immersed
in water.
• The unit can be completely immersed in wa-
ter.
• Ensure that the unit is immersed in water at
least up to the minimum immersion depth
marking.
N O T E
The desired water temperature can only be
achieved if the heating capacity of the heater is
suitable for the volume of water in the aquar-
ium (→ Technical data) and is positioned in an
area with good water circulation.
How to proceed:
 B, C, D
• Turn the temperature controller to the de-
sired temperature value.
• Insert the supplied suction cups into the
holder by twisting.
– Pay attention to the alignment of the tab
(it should point upwards or to the side).
• Clamp the holder to the unit.
- EN -
15