Oase HeatUp 25 Gebrauchsanleitung Und Garantieschein Seite 16

- EN -
• Position the unit with the heating element
pointing towards the floor of the aquarium on
a clean, smooth surface in an area with good
water circulation.
COMMISSIONING/START-UP
C A U T I O N
Risk of injury from hot surface!
Risk of burning parts of the body or risk of fire.
• Disconnect the heater from the mains and al-
low it to cool down before commencing any
work.
N O T E
For the use of the heater in a filter approved for
this purpose:
Danger of fire! The heater and filter can be de-
stroyed by the heat generated at the surface.
• Do not switch the heater on until the filter is
completely filled with water, switched on and
the water is continuously circulated.
16
N O T E
For use in an aquarium:
• Before switching on, ensure that the heater is
immersed in water at least up to the marking
for the minimum immersion depth.
N O T E
• Switch off the heater and allow it to cool
down before removing it from the water.
• Do not leave the heater unattended after re-
moving it from the water.
• Wait approx. 30 minutes before switching on
so that the thermostat can adjust to the tem-
perature of the water.
• Route the power connection cable such that
it forms a drip loop!
• Switching on: Connect the unit to the mains.
The unit switches on immediately.
• Switching off: Disconnect the unit from the
mains.
HeatUp 25/50/75/100/150/200/250/300