Service And Maintenance - LGB 25500 Handbuch

Multi-Train System
The model is equipped with a factory-installed onboard de-
coder for the LGB Multi-Train System. It can be used without
modifications on analog or digital layouts.
When operating with the Multi-Train System, the loco
features a "Back-EMF" function. This keeps the motor
speed constant, even when the load of the loco changes, for
example, in curves or on grades. This feature does not work
at top speed.
Programming the Decoder
Numerous functions on the decoder can be programmed
individually. To do this, function values are programmed in
registers (Configuration Variables - CVs). You also can pro-
gram the function values with the 55015 Universal Remote
Controller.
• For normal operation, it is not necessary to change the
function values.
• If programming results in unsatisfactory operation,
you can reprogram the factory pre-set values of most
important CVs: Program register CV 55 to function value
55. To reprogram the factory pre-set function values with
the 55015, select programming mode "P" (displays shows
"P --"). Then input 6, 5, and 5 and press the right arrow
button. The display shows "P --" again: Input 5, 5, and 5
and press the right arrow button again.
SERVICE
Lubrication
The axle bearings should be lubricated occasionally with a
small amount of LGB Maintenance Oil (50019).
Replacing the light bulbs
Remove the ring around the lantern lens. Carefully pry the
lens away from the lantern. Using tweezers, remove and
replace the bulb. Reassemble.
Replacing the traction tire
- Remove the two screws on each of the gearbox retainers
behind and in front of the gearbox.
- Pull the gearbox out of the frame.
- Use a small, straight-blade screwdriver to replace the
traction tire:
- Pry the old traction tire out of the wheel groove.
- Gently insert the new traction tire into the wheel groove.
- Make sure that the traction tire is seated properly in the
wheel groove.
- Reassemble.
9