Suck in water from vessel
DANGER
Never suck in water from a drinking water
container. Never suck in liquids which con-
tain solvents like lacquer thinner, petrol, oil
or unfiltered water. The sealings within the
device are not solvent resistant. The spray
mist of solvents is highly inflammable, ex-
plosive and poisonous.
Connect suction hose (minimum diame-
ter 3/4") with filter (accessory) to the
water connection point.
Set dosing value for detergent to "0".
Remove air from appliance before oper-
ation.
Note:
Do not use the Geka coupling (included in
delivery) for vacuuming operations! Not all
connector couplings are suitable for vacu-
uming operations (pump sucks air and
therefore does not build up pressure).
Dearating the appliance
Open the water supply.
Start the engine according to the oper-
ating instructions of the engine manu-
facturer.
To dearate the appliance, unscrew the
nozzle and allow the appliance to run
until the water exits in a bubble-free
state.
Switch off the appliance and fit the noz-
zle again.
Operation
DANGER
– Place the appliance on firm surface.
– The high-pressure cleaner must not be
used by children. (Risk of accidents on
account of improper use of the device).
– The high-pressure jet generates high
levels of noise when the device is in
use. Risk of hearing impairment. Al-
ways use proper hearing protection
while working with the device.
– The water jet coming out of the high-
pressure nozzle causes the gun to re-
coil. Further, an angular spray pipe can
cause additional torque. Hence, hold
the spray lance and gun firmly.
– Never direct the water jet on to persons,
animals, the appliance itself or electrical
components.
– Vehile tyres/ tyre valves may be
cleaned only with a minimum spray dis-
tance of 30 cm. Otherwise, the high
pressure spray can cause damage to
the vehicle tyre/ tyre valve. The discol-
ouring of the tyre is the fhe first sign of
damage. Damaged vehicle tyres are a
source of danger.
– Do not spray materials containing as-
bestos or other health-hazardous sub-
stances.
– The operator must wear proper safety
gear to be protected against the water
sprays.
– Pay attention to ensure that all screws
of all connecting hoses are tightened
properly.
– The lever of the hand spray gun must
not be locked during the operation.
– Do not spray flammable liquids.
Turning on the Appliance
Open the water supply.
Set the appliance switch at the engine
to "ON" and open the fuel supply valve.
Start the motor with the trigger gun
open according to the operating instruc-
tions of the motor manufacturer.
Note:
The spray lance can be removed to facili-
tate the start-up process.
Press the lever on the hand spray gun.
Close the hand spray gun.
Turn the casing of the nozzle till the de-
sired symbol matches the marking.
High pressure flat spray (25°)
for large dirt areas
High pressure circular spray
(0°) for specially stubborn dirt
– 4
EN
Triple nozzle
15