Spa Trouble-Shooting Guide - Legacy Whirlpool INT Enterprise SE Handbuch

SPA TROUBLE SHOOTING GUIDE
Note: For wiring outside of U.S. and Canada, GFCI may be referred to as a RCD (residual current
device). Be sure all local electrical codes are followed.
NOTHING ON THE SPA OPERATES
1. Check the control panel display for any messages. If there is a message, refer to the diagnostic
section on that model spa. There you will find the meaning of the message and what action is
to be taken.
2. If there is no message on your control panel, check and reset the GFCI and house breaker.
If the spa does not respond, contact your local service company.
PUMP(S) DO NOT OPERATE -
1. Press the "Jets" button on your control panel.
If you hear the pumps trying to operate:
A. Check that all the slice valves are open.
B. Pump may need to be primed.
C. Check that all jets are in their full open positions.
If you do not hear anything from the pump, contact your local dealer or service company.
POOR JET PERFORMANCE
1. Make sure pump is operating
2. Check that the water level is adequate (up to minimum safe water level)
3. Make sure the jets are open and the air controls are open.
DO NOT DIVE. DO NOT DIVE.
The GFCI should be located in a weather proof box close to the spa,
but no closer than 5 ft.
100 31