Error Messages - Roco Lokmaus 2 Handbuch

loco doesn't move speed step mode
of the Lokmaus 2
coder don't (128 speed step mode)
match.
sense of driving of the loco is in-
versed.
headlights of the pilot car (e.g. the
ICE from the Start Set 41203) don't
GB
match direction.
the speed step mode can't be
changed.
the display shows the message 'PA'.
E M
RROR ESSAGES
error-code E1 A short circuit on the programming track has occured. Please make sure that the loco is
error-code E2 Trying to read the decoder didn't have a result because the loco didn't answer. Please
error-code E3 the result of reading a decoder is higher than 99 and therefore the Lokmaus 2
error-code E6 The actual DataBUS address of the Lokmaus 2
error-code E7 The actual RocoNet address of the Lokmaus 2
error-code E8 A data communication error in the DataBUS has happened. If the system doesn't con-
error-code E9 The Lokmaus 2
34 34
and the loco-de-
®
not derailed and that there is no fault in the wiring of the programming track. A newly
converted loco may have a faulty wired decoder.
make sure that the loco is not derailed and that there is no fault in the wiring of the
programming track. A newly converted loco may have a faulty wired decoder.
display it on their 2-digits display. It can display values from 00 to 99. If the result is
higher then you get this error-message.
sage the Lokmaus 2 automatically starts to search for a new free device-address. If
®
you have disabled the autoconfiguration you must correct the device address yourself.
How to change the device-address you can read on page 31.
may occur because you added more devices to the system than defined in the menu C8.
How you raise the number of devices you read on page 31. This error message can also
appear in the moment that you plug the Lokmaus 2
transmission is connected later than the power supply of the Lokmaus 2
corrected automatically after a short time.
tinue after this error message please unplug the amplifier from the transformer and
re-plug it.
has received an unknown command or the data transmission was dis-
®
turbed. This error message also occurs if you try to read a decoder but the Lokmaus 2
is plugged to an amplifier (e.g. the amplifier 10761) that doesn't support this feature.
By pressing 'STOP' you release this error message.
The speed step mode for the address of the loco at the
Lokmaus 2 is wrong or the decoder desn't support this
®
mode. How to define the speed step mode see page 24, how
to program the CV29 you find on page 27.
the programming of the CV29 must be corrected to change
the sense of driving. How to program the CV29 you read on
page 27.
By programming the CV29 you must change the sense of
driving of of the pilot car. Put the pilot car without loco on
the programming track! How to program the CV29 you read
on page 27.
knob is not in middle position (00). In this position you can
control the speed step mode, but you can't change it. How to
change the speed step mode you can read on page 25.
an other Lokmaus 2 in the system is programming. You can
®
program only by one Lokmaus 2
time no other Lokmaus 2
ming procedure is finished, this message disappears auto-
matically and the locos re-start to run.
®
®
simultaneously. During this
®
can make an input. If the program-
®
is already in use. After this error mes-
is not addressed. This error message
to the system very slowly. The data
®
can't
®
. This error is
®
®