The Standard Programming Mode; Programming Of The Cv29; Professional Programming Mode - Roco Lokmaus 2 Handbuch

T S P
HE TANDARD ROGRAMMING MODE
In this mode you can change the most important parameters of a loco such as the address, minimum
speed, acceleration and deceleration delay and the maximum speed. Pressing 'P' and one of the func-
tion buttons 'star' or 'F1' to 'F4' leads you into the standard programming mode. By the same procedure
you select the parameter that you want to program (see the list below).
Meanwhile you press the two buttons the display shows 'SP' and all trains on the layout stop. The two
points of the display flash alternately to indicate the standard programming mode. After you released
the two buttons the mouse indicates in the display the default value for the selected parameter (con-
nected to an amplifier or central unit that can read out the decoder it indicates the actual setting of
the decoder).
If you want to change this value e.g. the loco address you select an othere setting by the 'up' or 'down'
button. Pressing the button 'P' you confirm the selection and start the programming procedure that
writes the setting into the decoder. This procedure takes some time depending on the programming
modes that are executed. The display indicates this procedure showing 'P'. After this procedure the
Lokmaus 2 returns automatically to the normal state and the locos restart to run. By pressing 'STOP'
®
you can return to the normal state without writing something into the decoder.
Pay attention to the valid range for the parameters! Please read the instruction of the loco Decoder.
This programming mode can be deactivated by the menu C3 – so it can't be used unintentionally
by children – see on page 31.
'P' + 'T' programs the address, value 01 to 99, default is 03
'P' + 'F1' defines the minimum speed, value 01 to 99, default is 08
'P' + 'F2' defines the acceleration delay, value 01 to 99, default is 04
'P' + 'F3' defines the deceleration delay, value 01 to 99, default is 04
'P' + 'F4' defines the maximum speed (only can be programmed if the decoder is load regulated)
value 01 to 99, default is 15
'P' + 'STOP' programs the CV29 that contains basic settings of the decoder value 01 to 99, default is 04
P
ROGRAMMING THE
The CV29 is used for the setup of the decoder. It defines the behaviour of the decoder according to the
facilities of the central unit and to your wishes. The CV29 sets up the following features:
â the sense of driving
â the speed step mode
â the automatical recognition of the DC operation (by this way you can use DC to stop the loco in
front of a red semaphore)
Value Sense
0 sense of driving: normal
1 sense of driving: inverted
2 sense of driving: normal
3 sense of driving: inverted
4 sense of driving: normal
5 sense of driving: inverted
6 sense of driving: normal
7 sense of driving: inverted
P P
ROFESSIONAL ROGRAMMING
Press the button 'P' for at least 8 seconds (this time can be changed by the menu C5 see page 31). You
enter the professional programming mode. The display shows 'EP' and both points of the display flash
simultaneously. Release 'P' and changes to indicates '01' for the CV01 the first memory of the decoder.
CV29
speed step mode14
speed step mode14
speed step mode28
speed step mode28
speed step mode14
speed step mode14
speed step mode28
speed step mode28
M
ODE
digital only
digital only
digital only
digital only
digital and DC
digital and DC
digital and DC (default)
digital and DC
www.roco.cc
GB
27