Cleaning The Brushes; Problem Solving - Medion MD 16192 Bedienungsanleitung

8.3. Cleaning the brushes

We recommend cleaning the brushes regularly. Carry out the following steps:
 Switch off the appliance and lay it on its back on a flat surface.
 Loosen the screw of each brush with a Phillips screwdriver. Hold the brushes
firmly and pull them directly upwards and out of the appliance.
 Remove dirt and hair that has collected on the brushes.
 After cleaning, reattach the brushes.
 After a certain time, the brushes should be replaced to ensure efficient cleaning
performance. Please contact our Service Centre for replacement accessories.
PLEASE NOTE
If the bristles become bent, immerse the brushes in hot water until they
resume their original form.

9. Problem solving

If the appliance malfunctions, please check first if you can eliminate the error
yourself with the help of the following overview.
Never try to repair the product yourself. Please contact our Service Centre or
another professional repair shop if a repair is necessary.
Problem
The appliance cannot be
switched on.
The indicator light flash-
es when the appliance is
switched on.
The robot vacuum cleaner
does not move.
A single tone sounds.
Sensor fault
A dual tone sounds.
The appliance is blocked
A triple tone sounds.
The side brushes do not
move.
Possible cause
The battery block is flat.
The battery block is flat.
The wheels are blocked.
The robot vacuum
cleaner is located on a
dark floor.
The sensor is covered.
The robot vacuum
cleaner is stuck.
Blocked by dirt.
Solution
 Recharge the battery
block fully for approx.
3.5 hours.
 Recharge the battery
block fully for approx.
3.5 hours.
 Remove all blockages.
 Remedy the problem
with the wheels.
 Place the robot vacu-
um cleaner on a light
coloured floor.
 Clean the sensor.
 Place the robot vacu-
um cleaner in a differ-
ent location.
 Remove the brushes,
clean them thoroughly
and replace them.
151 of 158
DE
FR
NL
ES
IT
EN