Setting The Start Time - Medion MD 16192 Bedienungsanleitung

NOTICE!
Before vacuuming on a carpet, please remove the brushes. This robot
vacuum cleaner is not suitable for use on deep pile carpets.
Every time a button is pressed you will hear a beep to confirm.
 Before switching on, disconnect the mains adapter plug from the appliance.
 Ensure that the dust container is clean and the filter is correctly inserted.
 Place the robot vacuum cleaner in an open area within the room.
 Switch the On/Off switch to the ON position and the appliance is now ready for
operation.
 Press the CLEAN button on the appliance or on the remote control in order to
start the cleaning process.
The LEDs for the indicator light will now be permanently lit.
 Press the CLEAN button again to interrupt the cleaning process. Press the
CLEAN button once more if you want to resume the cleaning process.
NOTICE!
However, if you do not press a button within 15 seconds, the robot
vacuum cleaner will return to sleep mode. You can switch the robot
vacuum cleaner directly into sleep mode while in operation by pressing
and holding down the CLEAN button for approx. three seconds.
The indicator light is switched off in sleep mode.
NOTICE!
The robot vacuum cleaner will automatically return to the charging
station when the battery level is low. The cleaning process will be
interrupted when the appliance returns to the charging station.
 Regularly clean the suction opening when the appliance is switched off (On/Off
switch in the OFF position) and empty the dust container after every use.

7.1. Setting the start time

In order to start a cleaning process in your absence, set a start time for the cleaning
process. Proceed as follows:
 Switch the On/Off switch to the ON position and the appliance is now ready for
operation.
 Press the PLAN button to set the start time.
The hour display flashes.
 Use the arrow buttons
the minutes display.
The minute display flashes.
 Use the arrow buttons
 Confirm your selection by pressing the PLAN button.
The start time is now set. The LEDs for the indicator light will flash. The cleaning
process will start at the preset time.
In order to deactivate the start time, set the start time to 00:00.
148 of 158
or to set the hour. Then press the
or to set the minutes.
button to set