Range Test; Maintenance And Care - Reely 4-Kanal-Fernsteueranlage 2,4 GHz Bedienungsanleitung

21. Range Test

Before the first start, the range of the remote control system must be tested. It is possible to operate the transmitter
at reduced output here.
For the range test, the model should be held safety at a height of about 1 m by a helper. The model must not rest on
a metal table or metal plate for this.
Proceed as follows for the range test:
• Push the binding button at the transmitter (also see figure 1, item 11) and switch on the transmitter with the button
pushed.
• Then start up the receiver.
• The green LED for the function display (see also figure 1, item 16) flashes in a 2 second cycle and the remote
control emits a signal sound every 2 seconds.
• Move away from the model now.
• Up to a distance of 30 - 50 steps, the model has to be completely controllable.
• Now, continue to increase the distance until the model no longer reacts to the control signals.
• Switch the transmitter off and on again. The transmitter now works at full transmission output.
• At full signal strengths, the model now has to react reliably to the remote control signals again.
After about 60 seconds, the remote control transmitter will automatically switch from reduced to full trans-
mission output.
Attention!
Never start your model while the transmitter output is still decreased!

22. Maintenance and Care

Clean the exterior of the remote control with a soft, dry cloth or brush only. Never use abrasive cleaning agents or
chemical solutions as these could damage the surfaces of the casings.
64