C) Charging The Rechargeable Batteries For Transmitter; Switching On The Transmitter - Reely 4-Kanal-Fernsteueranlage 2,4 GHz Bedienungsanleitung

c) Charging the Rechargeable Batteries for Transmitter

When rechargeable batteries are inserted, you can connect
the charger cable to the charging socket (1) to charge the
rechargeable batteries in the transmitter. Always make sure
the polarity of the connecting plug is correct. The inner con-
tact of the charging socket must be connected to the plus
terminal (+) and the outer contact to the minus terminal (-)
of the charger.
The charging current should be about 1/10 of the capac-
ity of the inserted rechargeable batteries. For rechargeable
batteries with a capacity of 2000 mAh, this corresponds to a
charging current of approx. 200 mA and charging time takes
approx. 14 h.
Since a protective diode is integrated in the transmitter, no
chargers can be used that briefly interrupt the charging cur-
rent in order to measure the voltage of the rechargeable bat-
tery. In this case, remove the rechargeable batteries from
the transmitter for charging.
Attention!
Only connect the charger when you have inserted rechargeable batteries (1.2 V/cell) in the transmitter.
Never try to recharge batteries (1.5 V/cell) with a charger.
In order to avoid damage to the internal conductor paths and connections, please do not use any quick
chargers. The maximum charging current must not exceed 300 mA!
d) Switching on the Transmitter
When new batteries or freshly charged rechargeable bat-
teries have been inserted, switch on the transmitter with the
on/off switch (see figure 1, item 8) for test purposes. Push
the operating button from the bottom to the top position.
First, the red LED for voltage supply will light up (also see
figure 1, item 17). A short term later, the remote control emits
two signals and the green LED for the function display (also
see figure 1, item 16) starts to light up.
When the delta or V-tail mixer is activated, the
green LED of the function display will not be per-
manently lit, but will flat at a quick rhythm.
If the voltage supply drops to less than 4.2 V, the green LED for undervoltage (also see figure 1, item 16) starts flash-
ing quickly and the transmitter will emit short signal sounds at the same rhythm. In this case, stop operation of your
model as quickly as possible.
To continue operating the transmitter, recharge the batteries or insert new batteries.
After you have verified the correct function of your transmitter, switch it off again.
Figure 3
Figure 4
45