Mounting The Receiver - Reely 4-Kanal-Fernsteueranlage 2,4 GHz Bedienungsanleitung

b) Mounting the Receiver
Installation of the receiver depends on the model. For this reason, you should always follow the recommendations
of the model manufacturer regarding the installation. Regardless of the model, you should always try to install the
receiver so that it is protected from dust, dirt, moisture and vibration in the best possible way.
Keep enough distance from motors and electronic flight or speed controllers. Metal or carbon parts have a shielding
effect and thus may considerably impair reception. In this case, it is sensible to relocate the aerial outwards through
a bore in the fuselage.
Two-sided adhesive foam (servo tape) or rubber rings that hold the foam-wrapped receiver securely in place are
suitable for fastening the receiver.
Attention!
The receiver aerial (1) is the unshielded part of
the aerial line and has a length that is precisely
dimensioned.
For this reason, you must not roll up the aerial,
place it in a loop or cut it off. This would decrease
the range significantly and thus pose a consider-
able safety risk.
48
Figure 7