Binding Function - Reely 4-Kanal-Fernsteueranlage 2,4 GHz Bedienungsanleitung

19. Binding Function

To enable transmitter and receiver to work together, they must be bound by the same digital code. In the delivery state,
transmitter and receiver are aligned with each other and can be used at once. The binding settings must be renewed
mainly after a replacement of the transmitter or receiver or to remove any interferences.
To perform the binding procedure, proceed as follows:
• Switch off the receiver and transmitter.
• Place receiver and transmitter close together (no more
than 1 meter distance).
• Switch on the transmitter and wait until both LED displays
(also see figure 1, items 16 and 17) at the transmitter are
lit.
• Push and hold the setup button at the receiver (also see
figure 6, item 2).
• Switch on the receiver while pushing Setup. When the
LED in the receiver (also see figure 6, item 3) starts flash-
ing quickly, release the setup button of the receiver (2)
again.
• Push and hold the binding button at the transmitter (also
see figure 1, item 11). If the green LED for the function
display (16) starts flashing fast, release the binding button
again. The LED in the receiver (3) goes out.
• When the green LED display at the transmitter remains
lit (after about 3 seconds), binding has been completed.
The LED in the receiver (3) remains lit again and signals
reception of the control signals of the transmitter.
• Then perform a function test of the system.
•
Attention!
After binding has been performed, the fail safe setting has to be performed again because any possible fail
safe programming is no longer active because of the binding process.
62
Figure 20