Lenze ECS Montageanleitung Seite 102

4 Electrical installation
Control terminals
Assignment of the plug connectors
Terminal strip X6
View
Cable cross−sections and screw−tightening torques
Cable type
Flexible
We recommend to use control cables with a cable cross−section of 0.25 mm
102
Terminal Function
X6/+24 Low−voltage supply of control
electronics
X6/GND Reference potential low−voltage
supply
X6/T1 Thermostat contact 1
X6/T2 Thermostat contact 2
X6/D24 Low−voltage supply X6/DO1
(digital output 1)
X6/DO1 Digital output 1
(for central controller enable
signal to connected axis
modules)
X6/DI1 Digital input 1
(for power supply enable/charge
of the DC bus)
X6/DI2 Digital input 2
(for central controller enable
signal to connected modules;
available at output X6/DO1)
Wire end ferrule Cable cross−section
Without wire end 0.08 ... 1.5 mm
ferrule
(AWG 28 ... 16)
With insulated wire 0.25 ... 0.5 mm
end ferrule
(AWG 22 ... 20)
Electrical data
20 ... 30 V DC, 0.5 A (max. 1 A)
for 24 V starting current:
max. 2 A for 50 ms
18 ... 30 V DC
24 V DC, 0.7 A (max. 1.4 A)
short−circuit−proof
LOW:
−3 ... +5 V;
−3 ... +1.5 mA
HIGH:
+15 ... +30 V;
+2 ... +15 mA
Input current at 24 V DC:
8 mA per input
Tightening torque
2
0.22 ... 0.25 Nm
(1.95 ... 2.2 lb−in)
2
l
Stripping length
5 mm for screw
connection
9 mm for spring
connection
2
.
EDKCSDE040 DE/EN/FR 5.0