During Operation - Reely 1542570 Bedienungsanleitung

• If batteries are used for the power supply of the transmitter, make sure that there is a sufficient rest
capacity (battery checker). If the batteries are empty, always replace the complete set, never individual
cells only.
• Before each operation, control the settings of the trim slider at the transmitter for different steering direc-
tions and, if necessary, set them.
• Always switch the transmitter on first. It is only afterwards that you may connect the flight battery of the
model or switch the model on. Otherwise unexpected reactions of the electric model airplane may occur
and the propeller can start to turn unintentionally!
• Check the correct and secure position of the propeller before each operation.
• Make sure that neither objects nor body parts are in the rotating and suction area of the propeller while
it is rotating.
c) During Operation
• Do not take any risks when operating the product! Your own safety and that of your environment is solely
down to you being responsible when dealing with the model.
• Improper operation can cause serious damage to people and property! Therefore, during operation,
ensure a sufficient safety distance to persons, animals and objects.
• Select an appropriate site for the operation of your model airplane.
• Fly your model only if your ability to respond is unrestricted. The influence of tiredness, alcohol or medi-
cine can cause incorrect responses.
• Do not direct your model towards spectators or towards you.
• Motor, flight control system and flight battery can heat during operation of the model. Therefore, take a
break of 5 - 10 minutes before re-charging the flight battery or before re-starting with a possibly existing
spare flight battery. The drive engine must cool down to ambient temperature.
• Always leave the remote control (transmitter) turned on, as long as the model is in operation. After land-
ing, always disconnect the flight battery first or switch the model off. It is only afterwards that the remote
control may be turned off.
• In case of a fault or a malfunction, correct the fault first then re-start the model.
• Don't expose your model and the remote control for a longer period of time to direct sunlight or exces-
sive heat.
• After use, the flight battery must be disconnected from the model and the transmitter switched off. Re-
move the batteries from the transmitter for extended storage.
34