Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ELECTRIC SAFETY
EN
•
Cut off the power before any maintenance or change on the machine.
•
Do not use this machine if it is impossible to turn it on/of by the switch.
•
The machine is equipped with a safety circuit-breaker to prevent it starting up again after
a voltage drop. Before you use the machine for the first time, check that the voltage
marked on the rating plate is the same as your mains voltage.
•
If you need to use extension cable, make sure its conductor cross-section is big enough for
the saw's power consumption.
DE
•
If you use a cable reel, the complete cable must be pulled off the reel.
•
Do not use the cable to pull the plug out of the socket. Protect the cable from heat, oil
and sharp edges.
•
Check the power cable regularly and have it replaced by an authorized specialist at the
first sign of any damage.
•
This electric tool complies with the pertinent safety regulations. Repairs are to be carried out only
CS
by a qualified electrician using original replacement parts or the user may suffer an accident.
•
Diameter of the lengthened cable is 2.5mm
•
Make sure to cut off power during braking.
•
Starting needs at least 1 minute!
•
Do not use powered damaged lengthened cable. There is a risk of injury by electric shock.
•
If the power supply is damaged, it can be replaced only by an authorized service or
a similarly qualified person. This will prevent contact with electrically powered parts
SK
BLADES
•
Note the direction of rotation of the motor and saw blade. Use only blades whose
permissible maximum speed is not lower than the maximum spindle speed of the circular
saw and of the material to be cut.
•
After you have switched off the motor, never slow down the saw blade by applying
PL
pressure to its side.
•
Only fit blades which are well sharpened and have no cracks or deformations.
•
Do not use circular saw blades made of high-alloy high-speed steel (HSS).
•
Only use original saw blades
•
Never use saw blades which do not comply with the data specified in this manual.
SAFETY INSTRUCTION FOR
HU
i
Make sure that your hands are in safety distance from cutting blade. Hold the saw
with both hands firmly. If you held the saw with both hands, they cannot be cut by
the blade. When you operate the saw, stand always away from the cutting level.
•
Do not touch under the material which you cut! Safety shield cannot save you before the
blade contact under the cutting material.
•
Adjust the cutting depth to thickness of the cutting log. Blade tooth lenght which you can
see under the cutting wood must be lower than lenght of one tooth.
•
Never hold the cutting log in your hand or over your knee. Place the log on extendable
bracket.
•
Do not let blade to contact electric wires. Contact with „living" conductor can cause that
metal parts will became „living" too and cause electric shock to operator.
•
When lengthwise cutting always use guiding ruler with straight edge. This increases
cutting accuracy and decreases danger of blade blocking.
•
Do not overload the machine so much, that the blade will stop or slower its rotations.
12 / 72
, If the length is over 20m, its diameter is 4mm
2
WORKING
WITH THE SAW
made for garden
.
2
Werbung
Kapitel
