Waeco SinePower MSP 702 Bedienungsanleitung Seite 47

SinePower
 Before connecting, set the main switch (fig. 2 1, page 4) to "Off".
 When setting up a socket distribution circuit (mains set-up), you must
comply with VDE 0100.
 Only use copper cables.
 Keep the cables as short as possible. The cables cannot be longer than
1.8 m.
 After running the cable, secure it with cable ties to the clips on the cable
socket.
 Keep to the required cable cross section and fit a cable fuse as close to
the battery as possible on the positive cable (see table).
NOTICE!
A
If you do not fit a fuse to the positive cable, the cables can over-
load, which might result in a fire.
Device
MSP 702
MSP 704
MSP 1012
MSP 1024
MSP 1512
MSP 1524
MSP 2012
MSP 2024
MSP 2512
MSP 2524
EN
Required cable cross section
25 mm²
15 mm²
35 mm²
25 mm²
35 mm²
25 mm²
70 mm²
55 mm²
95 mm²
70 mm²
Connecting the inverter
Cable fuse
100 A
50 A
200 A
100 A
200 A
100 A
250 A
150 A
400 A
200 A
47