Waeco SinePower MSP 702 Bedienungsanleitung Seite 38

Safety instructions
For installation on boats
WARNING!
!
 If electrical devices are incorrectly installed on boats, corrosion
damage might occur. Have the inverter installed by a specialist
(marine) electrician.
Electrical cables
WARNING!
!
 If cables have to be fed through metal walls or other walls with
sharp edges, use ducts or wire bushings to prevent damage.
 Do not lay cables which are loose or bent next to electrically
conductive material (metal).
 Do not pull on the cables.
 Do not lay the 230 V mains cable and the 12/24 Vg cable in the
same duct.
 Fasten the cables securely.
 Lay the cables so that they cannot be tripped over or damaged.
2.3 Operating the appliance safely
WARNING!
!
 Operate the device only if you are certain that the housing and
the cables are undamaged.
 Even after the fuse triggers, parts of the inverter remain live.
 Always disconnect the power supply when working on the de-
vice.
NOTICE!
A
 Make sure the air inlets and outlets of the device are not cov-
ered.
 Ensure good ventilation.
 Do not connect the 230 V output of the inverter (fig. 3 4,
page 4) to a different 230 V source.
38
SinePower
EN